Overview 

The PinScore™ PS-12232-R1 LED display system is a complete, drop-in replacement display system for Williams TAXI and POLICE FORCE pinball machines. The low-voltage, high-efficiency displays use only your game's 5-volt supply and will work on pinball machines with failed high voltage power supplies. With custom-engineered color-matched LED (light emitting diode) blocks, the displays retain the game’s factory look while adding features like adjustable brightness and self-test.

This kit contains everything needed to replace displays on the listed compatible games. 

The PS-12232-R1 supersedes the PS-12232-P16-R1, is compatible with the same games, and is functionally identical.  The PS-12232-R1 replaces Williams factory part #D-12232-2.

Features

• Plug ‘n Play installation; no soldering required
• Low power consumption
• Adjustable flicker-free brightness control
• Self-test diagnostic button
• 5V powered, no high-voltage required
• Black matte finish digit faces
• Environmentally-friendly lead-free RoHS compliance
• 5-year warranty
• Made in the USA 

Kit Contents

Installation

• Installation time: about 20 minutes.
• Tools required: ¼” nutdriver and/or Phillips screwdriver. 

1. Remove Old Displays.
   1. Turn off and unplug the main power from your pinball machine. 
   2. Remove game backglass (Check owner’s manual for specific instructions).
   3. Unplug all display boards, connecting cables and remove original display board.
2. Mount the new boards.
   1. Hand-tighten the screws so that you may align the displays with the backglass windows before finally securing the board.
   2. If further alignment is necessary, you may adjust the insert panel door hinges and latch in the backbox.
3. Connect the cables.
   1. Attach the original power cables to the board.  These are all keyed and will only fit in the correct connectors. 
   2. Attach the flat ribbon cable that connects to your MPU board to the connector labeled MPU Cable (J4). Make sure to align the red-striped side of the cable with Pin #1 on the connector, which faces the test switch and is labeled "RED".  
   3. Attach the included new ribbon cable to the PS-10866 jackpot display (J1), again being sure to align the red stripe with Pin 1, labeled "RED".
   4. Attach the other end of the ribbon cable to the Master board"Left External Display" connector (J2). 
   5. The Right External Display Connector, J1, is NOT USED on the Master board.
4. Verify Installation.
   1. Double-check all connections, plug in the machine, and turn the game on. The LED display will light up. 
   2. Press the diagnostic pushbutton labeled SW1/DISPLAY TEST on the PS-12232 board.  All segments of all displays should illuminate, indicating that all components of the PinScore™ system are operating correctly.  
   3. The thumbwheel brightness control labeled R17 on the right side of the board allows you to set your preferred illumination level. 
5. Play Pinball! 

Warranty

All PinScore™ display products are covered by a 5-year, transferable warranty.  Should your display fail, contact your distributor for repair or replacement options. PinScore™ products will be repaired or replaced at the distributor’s discretion.

PinScore™ LED displays are a replacement product for aging pinball machines. While PinScore™ LED displays are carefully engineered to replace as many high-failure parts as possible and retain robustness, there remains a possibility that other parts of your machine may need to be repaired before your game will function correctly.   These parts include but are not limited to your machine’s MPU,  transformer, wiring, and fuses. The PinScore™ warranty does not cover damage caused by improper installation, faulty wiring, aftermarket game modifications, and incorrect aftermarket repairs.